Conrad GX106 Bedienungsanleitung Seite 81

• Example:
Relais1*=1
The relay for SMS output 1 (figure 1, item 6) is switched on after receipt of the SMS. The
indicator LED lights up.
This condition remains active until the SMS output 1 is deactivated again with a new SMS.
For this, send an SMS with the following text:
Relais1*=0
The relay for SMS output 1 (figure 1, item 6) is switched off after receipt of the SMS. The
indicator LED goes out.
If the "SMS output 1" function was correct, this function can be freely used from now on. To
control a function, connect a device to the "SMS output 1" relay contacts. For this, observe
the maximum permissible voltages and currents in the technical data and the diagram note
for connection of a consumer by relay at the end of the operating instructions.
A relay is already connected to the output "SMS1".
The SMS outputs 2 to 4 (figure 1, item 7) work according to SMS output 1. No relays
are connected to these outputs. At your own discretion, the control voltage (approx.
4 V, max. 100 mA) can also directly affect other electronic circuits when the output is
active. However, a relay (Conrad item no. 502892) of the relay PCB (Conrad item no.
585498) can also be be directly connected to these outputs.
81