Conrad GX106 Bedienungsanleitung Seite 73

Important!
Generally, the GSM module only indicates changes that persist for at least 3 seconds
or undercut/exceed the threshold value. If you have sent a new configuration to the
GSM module, the GSM module will restart automatically. The GSM module takes 1
minute after restart before it can perform any changes to the sensors or commands.
This waiting time must be strictly observed!
The following information is displayed at the status request:
Display Control Software
T1 = 0C
T2 = 0C
TEMP1-4 = L,L,L,L
IN1, IN2 = H,H
SMS1-4 = L,L,L,L
ADC = 75 mV
PWM = 128
INCALL = L
Level = 15

The status request values indicated in the chapter are only examples to display the
indicated values and may deviate depending on progress of your configuration.
The following values apply for the "Level" display value:
Status indicator
99
0
1 to 5
6 to 9
10 to 14
15 to 31
Meaning
The temperature at temperature sensor 1 is 0 °C
The temperature at temperature sensor 2 is 0 °C
The control outputs TEMP1-4 are off (L = low)
The control inputs IN1-2 are open (H = high)
The control outputs SMS1-4 are off (L = low)
75 mV were measured at input ADC
the PWM output is set to 128 (approx. 50% = centre)
The control input INCALL is not active (L = low)
the reception level for the GSM module is 15
Software bar display
5 red bars
1 red bar
1 to 2 green bars
3 green bars
4 green bars
5 green bars
Meaning
no reception or not logged in
no reception
bad reception
minimum permissible reception strength
good reception
good to very good reception
73