General Information On The "Status" Button - Conrad GX106 Bedienungsanleitung

12. General Information on the "Status" Button

The module performs a reset and dials into the GSM network once a configuration was
transferred to the GSM module. Once the green GSM LED flashes slowly (LED on for 1 second,
then 3 seconds break), the status of all inputs and outputs can be displayed in "Communication".
• For this, set the COM interface recognised in the device manager.
• Click the button "Status" in the control software.
• Then a display similar to a response SMS appears (see following chapter "Response"),
which is updated approx. every 2.5 seconds.
• If the GSM module has sent a message, the message "SMS sent", "FAX sent" or "EMAIL sent"
appears.
• If no reception is possible, "NO NET!" is displayed.
In this case, check the receiver quality at the location of the GSM aerial with a mobile phone.
Also note that the GSM aerial should be attached as far away from the GSM module as
possible.
• If the GSM module is presently being called, "Call detected" and the phone number appear
and the green SMS LED is permanently lit.
• If the GSM module has received an SMS, "SMS received" appears: and the SMS content is
displayed for approx. 1 minute.
72