Installation And Configuration Of The Outputs; A) "Incall" Output - Conrad GX106 Bedienungsanleitung

15. Installation and Configuration of the Outputs

a) "INCALL" Output

The "INCALL" output switches on for a defined time when the GSM module is called. Because
the GSM module does not pick up, this is free of charge!
Jut call the GSM module and let it ring a few times. Then the "INCALL" output switches on for
the time set in the control software and then off again automatically.
This is ideal, e.g., for a garage door opener or front door light. The activation time can be set
in 12 stages from 0.3 seconds to 24 hours.
Proceed as follows to use the "INCALL" output:
• Enter the phone number of the phone with which you
want to call in the top line of "Phone" in "General
Settings".
• The phone number must be entered in international
format.
Wrong: 01701234567
Correct: +491701234567
• Click the checkbox "Used" in "Switch on output for"
so that the checkmark appears. The "INCALL" output
is now active.
• Click the switching duration "10 sec" in "1 Incall
output".
• For a selection of phone numbers, choose one of the
following options:
"Everyone can call": The "INCALL" output switches
the connected relay for any call received.
"or called by all": In this configuration, the GSM module can be controlled by any phone
number stored in the control software in "Phone".
"or from" (recommended for initial commissioning): The GSM module can only be controlled
by phone numbers selected by clicking them.
77