B) Sms Outputs "Sms1" To "Sms4 - Conrad GX106 Bedienungsanleitung

b) SMS Outputs "SMS1" to "SMS4"

The outputs "SMS1" to "SMS4" can be activated or deactivated by sending an SMS to the GSM
module. A relay is already connected to the output "SMS1". A relay (Conrad item no. 502892,
not included in the delivery) or a relay PCB (Conrad item no. 585498, not included in the
delivery) can be directly connected to the remaining outputs. Every SMS output has its own
indicator LED that visually displays the activation process.
The relay switching contacts can be used to close or open electrical circuits. A separate
message text can be entered for each of the 4 outputs.
For switching, send an SMS with the message text for the respective output with the appendix
"=1" for activation or "=0" for deactivation (without quotes).

When sending SMS, always observe that the "Command texts" from the mobile phone
correspond precisely to the texts stored in the control software or the GSM module.
Capitalisation must be observed as well as spaces. The text must always contain 8
characters. If the entered text is shorter, you have to enter the respective number of
spaces. The command text must be followed by the command without any space (e.g.
"=1" for activate). If only one output is used, this must be output "SMS1".
Proceed as follows to configure the SMS outputs:
• Check "Used" for "Output 1" in the control software,
"4 SMS Outputs" for the output "SMS1" to be switched
on.
• Enter the message text "Relais1".

The "message text" (or from the user's view,
the "command text") always has to be 8
characters long. If the entered text is shorter,
you have to enter spaces (e.g. indicated with
* here: Relais1*=1; also see adjacent figure in
"The message text must be").
Every output must be assigned its own
"message or command text" (e.g. output1,
output2, etc.). Selection of the desired phone
numbers is determined in output 1 and is valid
for all four outputs.
79