Addressing; Led Brightness Setting; Non-Dmx Modi - EuroLite LED Bar 288/5 RGB Bedienungsanleitung

Only use a stereo shielded cable and 3-pin XLR-plugs and connectors in order to connect the controller with
the device or one device with another.
Occupation of the XLR-connection:
If you are using controllers with this occupation, you can connect the DMX-output of the controller directly
with the DMX-input of the first device in the DMX-chain. If you wish to connect DMX-controllers with other
XLR-outputs, you need to use adapter-cables.
Building a serial DMX-chain:
Connect the DMX-output of the first device in the DMX-chain with the DMX-input of the next device. Always
connect one output with the input of the next device until all devices are connected.
Note:
It's necessary to insert the XLR termination plug (with 120 Ohm) in the last lighting in the link in order to
ensure proper transmission on the DMX data link.

Addressing

The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the LED Bar 288/5 RGB will respond to the controller.
For address setting, press the Encoder and turn it turn it clock-wise to increase the value and counter-
clockwise to decrease the value. Press the Encoder again to confirm.
Controlling:
After having addressed the LED Bar 288/5 RGB, you may now start operating it via your lighting controller.

LED Brightness Setting

The Control Board allows you to define the LED brightness. Press the Encoder and turn it turn until the LCD
Display shows the following:
Manual Blue ***
Manual Green***
Manual Red ***
Value setting : 0 – 255, the higher the value, the brighter the LEDs. Press the Encoder and turn it clock-wise
to increase the value and counter-clockwise to decrease the value. Press the Encoder again to confirm.

Non-DMX Modi

Press the Encoder and turn it turn until the LCD Display shows the following:
No DMX Auto/Sound/Manual
Press the Encoder again to confirm. The sequences Auto/Sound/Manual follow each other in a continuous
loop: Auto = automatic, Sound = sound control, Manual = manual. Press the Encoder again to confirm the
desired mode.
(to set the brightness of the blue LEDs)
(to set the brightness of the green LEDs)
(to set the brightness of the red LEDs)
22/51 00032381.DOC, Version 1.0