Speaker Settings - Sharp SD-AT50H Bedienungsanleitung

Speaker settings

SD-AT50H
DX-AT50H
ENGLISH
The speaker settings are not displayed on the TV screen.
! Speaker size setting
You can change the sizes of the speakers if they are not supplied ones.
1
Press the SETUP AMP button, and the
SIZE". Then press the ENTER button.
2
Within 10 seconds, press the
select the desired speaker.
The indicators of selected speakers flash.
3
Within 10 seconds, press the
To set sizes of other speakers, repeat the operation from step 2.
E-41
or button to select "SP
or button to
or button to select their sizes.
Caution:
To set the speaker size, set the sound mode to "STANDARD".
Note:
The recommended size is set for the supplied speakers. See the upper table on page
42 for other speakers.
! Speaker delay setting
When some of the speakers are at a different distance from the listening point, you
can select the speaker delay to make it seem as though the speaker distances are
the same.
1
Press the SETUP AMP button, and the
DELAY". Then press the ENTER button.
2
Within 30 seconds, press the or
speaker.
3
Within 30 seconds, press the
or button to select the distance
and press the ENTER button.
" You can change the distance in 0.1 m steps.
" To set the distance of other speakers, repeat the operation from step 2.
Measure the distance between each speaker and the listening position, and set
the speaker delay.
In the left illustration, the front speakers, the
CT
centre speaker, and the subwoofer are posi-
tioned at 3 m, and the surround speakers are
FR
FL
at 4 m from the listening position.
SW
3 m 3 m
3 m
3 m
4 m
4 m
SL SR
Note:
See the lower table on page 42 for the adjustable range.
02/8/28 SD-AT50H(H)E5.fm
or button to select "SP
button to select the desired