Remote Control; Battery Installation - Sharp SD-AT50H Bedienungsanleitung

Remote control

SD-AT50H
DX-AT50H
ENGLISH

! Battery installation

1 Open the battery cover.
2 Insert the batteries according to the direction indicated in the bat-
tery compartment.
When inserting or removing the batteries, push them towards the
nals.
3 Close the battery cover.
Precautions for battery use:
" Replace all old batteries with new ones at the same time.
" Do not mix old and new batteries.
" Remove the batteries if the system will not be used for long periods of time. This
will prevent potential damage due to battery leakage.
Caution:
" Do not use rechargeable batteries (nickel-cadmium battery, etc.).
" Installing the batteries incorrectly may cause the system to malfunction.
Notes concerning use:
" Replace the batteries if the operating distance is reduced or if the operation
becomes erratic. Purchase 2 "AA" size batteries (UM/SUM-3, R6, HP-7 or similar).
" Periodically clean the transmitter on the remote control and the sensor on the AV
control unit with a soft cloth.
" Exposing the sensor on the AV control unit to strong light may interfere with oper-
ation. Change the lighting or the direction of the AV control unit.
" Keep the remote control away from moisture, heat, shock, and vibrations.
E-17
! Test of the remote control
Check the remote control after checking all the connections (see pages 11 - 18).
Point the remote control directly at the remote sensor on the AV control unit.
Point the remote control at the AV control unit as well to operate the DVD player.
battery termi-
The remote control can be used within the range shown below:
Press the ON/STAND-BY button. Does the power turn on? Now, you can enjoy your
system.
Remote sensor
02/8/28
DVD player
AV control unit
0.2 m - 6 m
(8" - 20')
SD-AT50H(H)E2.fm