Listening To The Radio - Sharp SD-AT50H Bedienungsanleitung

Listening to the radio

SD-AT50H
DX-AT50H
ENGLISH
1
Press the ON/STAND-BY button to turn the power on.
2
To enter tuner function, display "FM" or "AM" by pressing the
FUNCTION button.
The DVD player automatically enters the power stand-by mode.
E-25
3
Press the BAND button repeatedly to select the desired frequency
band (FM or AM).
4
Press the TUNING ( or ) button to tune in to the desired station.
Manual tuning:
Press the TUNING button as many times as required to tune in to the desired
station.
Auto tuning:
When the TUNING button is pressed for more than 0.5 seconds, scanning will
start automatically and the tuner will stop at the first receivable broadcast station.
Notes:
" When radio interference occurs, auto scan tuning may stop automatically at
that point.
" Auto scan tuning will skip weak signal stations.
" To stop the auto tuning, press the TUNING button again.
" When an RDS (Radio Data System) station is tuned in, the frequency will be
displayed first, and then the RDS indicator will light. Finally, the station name
will appear.
" Full auto tuning can be achieved for RDS stations "ASPM", see page 45.
To receive an FM stereo transmission:
Press the BAND button to display the "STEREO" indicator.
" "ST" will appear when an FM broadcast is in stereo.
FM stereo receiving indicator
FM stereo mode indicator
" If the FM reception is weak, press the BAND button to extinguish the "STEREO"
indicator. The reception changes to monaural, and the sound becomes clearer.
After use:
Press the ON/STAND-BY button to enter the power stand-by mode.
02/8/28 SD-AT50H(H)E3.fm