General Control; To Turn The Power On - Sharp SD-AT50H Bedienungsanleitung

General control

! Connecting the AC power lead
Subwoofer/amplifier unit:
After checking all the connections, connect the AC power lead to the AC power input
socket, then to the wall socket.
(AC INPUT)
DVD player:
After checking all the connections, plug the DVD player into the wall socket.
Notes:
" The power is supplied to the AV control unit by the subwoofer/amplifier unit. The
AV control unit is not equipped with a power lead.
" Never use a power lead other than the one supplied. Otherwise, a malfunction or
an accident may occur.
" Unplug the DVD player and the subwoofer/amplifier unit if they will not be used for
a prolonged period of time.
Power indicator

! To turn the power on

Press the ON/STAND-BY button.
The power indicator lights up.
If the power does not turn on, check if the power leads are plugged in properly.
Notes:
" When the ON/STAND-BY button on the DVD player is pressed, the system turns
on.
" When the ON/STAND-BY button on the AV control unit or the remote control is
pressed:
Wall socket
In DVD function: The system turns on.
(AC 230 V, 50 Hz)
In other functions: The system except the DVD player turns on.
! Volume control
Press the VOLUME + button to increase the volume and the VOLUME - button for
decreasing.
Wall socket
(AC 230 V, 50 Hz)
! To change the display brightness (2 levels)
When the input is not DVD, you can change the brightness of the AV control unit dis-
play by holding down the DISPLAY button on the remote control for 2 seconds or
more.
Caution:
When in DVD function, the DISPLAY button cannot switch the brightness.
The display brightness depends on the setting of "PANEL DISPLAY" of "Changing
the initial setting of DVD" (see page 20).
You can switch the display brightness of the AV control unit and the DVD player.
.....
0 1 2 39 40
Dimmed Brightened
02/8/28 SD-AT50H(H)E2.fm
SD-AT50H
DX-AT50H
ENGLISH
8
E-18