PR Elecronics 9116 Handbuch Seite 177

safety Manual
[58] Relay setpoint - Read only
[59] select language
[60] Use process calibration values?
[61] set value for low calibration point
[62] set value for high calibration point
[63] enable Rail status signal output?
[64] enable sil configuration lock?
0...20 ma is not a valid output range for sil operation
[65] is channel using process-compensated calibration
data?
[66] configuration sil status (open / locked)
[80] sensor short circuit
[81] sensor wire breakage
[82] Display underrange
[83] Display overrange
[84] input underrange
[85] input overrange
[86] input error - check input connections and reset
power
[87] output error - check input connentions and reset
power
[88] Flash memory error - chek configuration
[89] invalid configuration type or version
[90] Hardware error
[91] cJc sensor error - check device temperature
[92] cJc error - check cJc connector block
[93] No communication
22
9116 UNiVeRsal coNVeRteR
Version No. V1R0