If the engine is operated in very dusty environments,
clean the air filter daily or after every ten operating
hours.
Never run the engine without an air filter or with a
damaged air filter insert. This would allow dirt into the
engine, which would result in severe damage to the
engine.
The manufacturer is not responsible for the resulting
damages; the user solely bears the risk.
13.3 Checking the spark plug (Fig. 10)
Caution! Danger of burning!
Switch off the engine and allow it to cool.
Clean or replace spark plug as required:
1.
Remove the spark plug connector (e) and clean
any dirt from the spark plug area.
2.
Unscrew the spark plug and check it.
3.
If there is any damage, e.g. cracks or chips, re-
place the spark plug.
4.
Clean the spark plug electrodes with a wire brush.
5.
Check and set the electrode gap.
6.
Screw the spark plug in and tighten with the sup-
plied spark plug spanner (K).
7.
Place the spark plug connector (e) on the spark
plug.
When replacing, ensure that no dirt gets into the cyl-
inder head.
Check the fit of the spark plug.
A loose spark plug can cause damage to the engine
by overheating.
Pulling too hard can damage the thread in the cylinder
head.
The manufacturer is not responsible for the resulting
damages; the user solely bears the risk. Only use the
recommended spark plugs or identical spark plugs.
13.4 Repair & ordering spare parts
Important note in the case of repairs:
When returning the product for repair, for safety rea-
sons, ensure that it is free of oil and fuel when it is sent
to the service centre.
Service information
With this product, it is necessary to note that the follow-
ing parts are subject to natural or usage-related wear,
or that the following parts are required as consuma-
bles.
Wearing parts*: Spark plug, filter
30 | GB
* may not be included in the scope of delivery!
Spare parts and accessories can be obtained from our
Service Centre. To do this, scan the QR code on the
front page.
14. Disposal and recycling
Notes for packaging
Notes on the electrical and electronic equipment
act (ElektroG)
Waste electrical and electronic equipment
does not belong in household waste, but
must be collected and disposed of sepa-
rately!
• Used batteries or rechargeable batteries that are
not installed permanently in the old device must be
removed non-destructively before disposal! Their
disposal is regulated by the battery act.
• Owners or users of electrical and electronic devices
are legally obliged to return them after use.
• The end user is responsible for deleting their per-
sonal data from the old device being disposed of!
• The symbol of the crossed-out dustbin means that
waste electrical and electronic equipment must not
be disposed of with household waste.
• Waste electrical and electronic equipment can be
handed in free of charge at the following places:
- Public disposal or collection points (e.g. municipal
works yards).
- Points of sale of electrical devices (stationary and
online), provided that dealers are obliged to take
them back or offer to do so voluntarily.
- Up to three waste electrical devices per type of
device, with an edge length of no more than 25
centimetres, can be returned free of charge to
the manufacturer without prior purchase of a new
device from the manufacturer or taken to another
authorised collection point in your vicinity.
- Further supplementary take-back conditions of
the manufacturers and distributors can be ob-
tained from the respective customer service.
• If the manufacturer delivers a new electrical device
to a private household, the manufacturer can ar-
www.scheppach.com
The packaging materials are recy-
clable. Please dispose of packag-
ing in an environmentally friendly
manner.