Herunterladen Inhalt Inhalt Diese Seite drucken

Service Information - Scheppach 5806204986 Original Bedienungsanleitung

Inverter stromerzeuger
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

• Clean the filter elements with soapy water. After rinse the filter elements with clear water and allow
to dry thoroughly before refitting.
• Reassemble in reverse order
m WARNING
NEVER use gasoline or cleaning solvents with a low flash point to clean the air filter element. A fire
or explosion could result.
Note
Never run the engine without or with a damaged air filter. Dirt gets so into the engine, causing serious
engine damage can occur. In this case, seller, and manufacturer disassociate from any warranty.
Check, clean and replace spark plug
Check the spark plug after 10 hours on dirt and grime. If necessary, clean it with a copper wire brush.
Maintenance the spark plug after 50 hours of operation
• Open the spark plug cover (Fig. 9)
• Remove the ignition cable with plug. (Fig. 9 Pos. D)
• Remove any dirt from the base of the spark plug.
• Use the enclosed spark plug wrench to remove the spark plug.
• Check the spark plug visually. Remove any debris with a wire brush.
• Look for discoloration on the top of the spark plug. By default, the color should be bright.
• Check the spark plug gap. An acceptable gap width is 0.6 to 0.7 mm (Fig. 11)
• Remove the spark plug carefully by hand.
• If the plug has been inserted, tighten them with a spark plug wrench.
• Attach the spark plug wire with connector on the spark plug.
NOTE
A loose spark plug can overheat and damage the engine. And overtightening the spark plug can
damage the threads in the cylinder head.

Service information

Please note that the following parts of this product are subject to normal or natural wear and that the
following parts are therefore also required for use as consumables.
Wear parts*: spark plug
* Not necessarily included in the scope of delivery!
Cleaning
• Keep all safety devices, air vents and the motor housing free of dirt and dust. Wipe the equipment
with a clean cloth or clean it with compressed air at low pressure.
• We recommend that you clean your device after each use.
• Clean the unit regularly with a damp cloth and some soft soap. Do not use cleaning agents or sol-
vents; they may damage the plastic parts of the appliance. Make sure that no water can get inside
the unit.
36 | GB
www.scheppach.com

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Igt2500

Inhaltsverzeichnis