Ordering Spare Parts; Please Provide The Following Information In The Event Of Any Enquiries; Service Information; Storage - Scheppach SG7300 Original Bedienungsanleitung

3. Remove the fuel filter insert. Clean it in a non­flam-
mable solvent or a solvent with a high flash point.
4. Reinsert the fuel filter insert.
5. Close the fuel filler cap (1).

13. Ordering spare parts

Please provide the following information in the
event of any enquiries:
• Machine data - type plate
• Engine data - type plate
Important note in the case of repairs:
For return delivery of the device for repair, please en-
sure for safety reasons that it is free of oil and fuel when
it is sent to the service centre.
13.1 Ordering spare parts
Please provide the following information when order-
ing spare parts:
• Device type
• Device article number

Service information

Note that the following parts on this device are subject
to natural or usage-related wear, or that the following
parts are required as consumables.
Wearing parts*: Spark plug, air filter
* may not be included in the scope of delivery!
Spare parts and accessories can be obtained from our
Service Centre. To do this, scan the QR code on the
front page.
Spare parts:
Battery - article no.: 5906203701

14. Storage

m DANGER!
Risk of fire and explosion!
Storing the product near potential sources of ignition
can result in a fire or an explosion. This can lead to
severe burns or death.
- Eliminate possible sources of ignition, such as fur-
naces, hot water boilers with gas, gas dryers, etc.
38 | GB
NOTE!
Risk of damage!
If the product is not stored properly, the engine can be
damaged.
- Store the product protected against dirt, dust and
moisture.
14.1

Preparation for storage

1. Empty the fuel tank using a fuel extraction pump
(see section 13.3).
Warning: Do not remove the petrol in enclosed
spaces, near fire or when smoking. Petrol fumes
can cause explosions and fire.
2. Carry out an oil change (see section 11.3).
3. To do so, remove the used engine oil from a warm
engine and refill with fresh oil.
4. Remove the spark plug (20a).
5. Fill the cylinder with approx. 20 ml of oil from an
oil can.
6. Pull the pull starter (17) slowly so that the oil pro-
tects the inside of the cylinder.
7. Screw the spark plug (20a) back in.
8. The ignition key (14) must always be removed from
the ignition lock (14a) and stored securely to pre-
vent unauthorised or improper use by children and
other persons.
9. When the device is taken out of service for an ex-
tended period of time, before starting work on or
near electrical components, disconnect the bat-
tery connection cable. We recommend removing
the battery (9) and storing it fully charged in a dry
and locked room.
10. Store the device in a well-ventilated place or area.
14.2 Removing the battery (9) (Fig. 1)
1. Remove the battery holder by removing the two
hexagonal screws with the enclosed open-end
spanner SW10 (B).
2. Remove the battery (9).
3. Pull the protective caps from both terminals of the
battery (9) and store them safely.
4. Remove the two pole cables from the battery (9)
with a Phillips screwdriver (F) (not enclosed).
Ensure that batteries are secured against unauthorised
use (e.g. by children).
Charge the battery (9) during the winter 1-2 times
to ensure that the full charging capacity is main-
tained. Incorrect storage can damage the battery
(9). In this case, the warranty is void.
www.scheppach.com