Introduction; Product Description (Fig. 1, 1A); Scope Of Delivery (Fig. 2); Proper Use - Scheppach Sg3200X Original Bedienungsanleitung

1.

Introduction

Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer,
We hope your new product brings you much enjoyment
and success.
Note:
In accordance with the applicable product liability laws,
the manufacturer of this product assumes no liability
for damage to the product or caused by the product
arising from:
• Improper handling
• Failure to comply with the operating manual
• Repairs carried out by third parties, unauthorised
specialists
• Installing and replacing non-original spare parts
• Improper use
• Failures of the electrical system due to failure to
observe the national electrical requirements and
regulations.
Note:
The operating manual is part of this product. It includes
important instructions for the safe, proper and econom-
ic operation of the product, for avoiding danger, for min-
imising repair costs and downtimes and for increasing
the reliability and extending the service life of the prod-
uct. In addition to the safety instructions in this operat-
ing manual, you must also observe the regulations ap-
plicable to the operation of the product in your country.
Familiarise yourself with all operating and safety in-
structions before using the product. Only operate the
product as described and for the specified areas of ap-
plication. Keep the operating manual in a good place
and hand over all documents when passing the product
on to third parties.

2. Product description (Fig. 1, 1a)

1. Fuel filler cap
2. Fuel gauge
3. Choke lever
4. Fuel valve
5. Filter cover
6. Pull starter
7. Grip screw
8. Transport handle
9. On/off switch
10. Oil filler cap with scale
11. Voltage switch
11a. Socket - 115V
11b. Socket - 230V
12. Earthing screw
13. Disconnect switch
14. Support feet
15. Transport wheels
16. Exhaust pipe
17. Engine
18. Tank
19. Frame

3. Scope of delivery (Fig. 2)

Item Quan-
tity
A 1x
B 2x
C 2x
D 2x
E 3x
F 2x
G 1x
H 2x
J 1x
K 1x
L 1x

4. Proper use

The product may only be used in the intended manner.
Any use beyond this is improper.
The user/operator, not the manufacturer, is responsible
for damages or injuries of any type resulting from this.
An element of the intended use is also the observance
of the safety instructions, as well as the assembly in-
structions and operating information in the operating
manual.
Persons who operate and maintain the product must be
familiar with the manual and must be informed about
potential dangers.
In addition, the applicable accident prevention regula-
www.scheppach.com
Designation
Transport handle (8)
Transport wheels (15)
Wheel axle Ø10x97mm +
Washer
Spring split pin
Hexagon bolt M8x45mm + nut M8
Hexagon bolt M8x40mm + nut M8
Generator
Support feet (14)
Funnel with hose
Spark plug wrench
Operating manual
GB | 23