Scheppach HM100T Originalbetriebsanleitung Seite 41

Saw width x saw depth at 2 x
45° (double mitre cut)
Protection class
Weight
Subject to technical changes!
* Operating mode S6, uninterrupted, periodic opera-
tion. The mode comprises of a start-up period, a time
with constant load and an idle time. The operating time
is 10 mins, the relative duty cycle is 25% of the oper-
ating time.
Noise and vibration
m Warning: Noise can have serious effects on your
health. If the machine noise exceeds 85 dB, please
wear suitable hearing protection.
Information on noise development measured per DIN
ENISO 3744; 11/95, E DIN EN 31201; 6/93, ISO7960
Annex A; 2/95
Excessive noise can result in a loss of hearing. Total vi-
bration emission values (vector sum of three directions)
determined per EN 61029.
Noise data
Sound power level L
WA
Sound pressure level L
pA
Uncertainty K
wa/pA
Vibration parameters
Vibration emission value a
Uncertainty K
h
The specified vibration emission value has been meas-
ured according to a standardised test procedure and can
be used for comparison of one power tool with another.
The specified vibration emission value can also be
used for an initial assessment of the load.
m
WARNING
The vibration emission value can vary from the spec-
ified value during the actual use of the power tool,
depending on the type and the manner in which the
electric tool is used.
Try to minimise stress from vibrations as low as possi-
ble. Some examples of means for reducing the vibra-
tion stress are wearing gloves while using the tool and
60 x 35 mm
approx. 19 kg
105.5 dB
92.5 dB
3.0 dB
1.74 m/s²
h
1.5 m/s²
www.scheppach.com
limiting work time. In the process all parts of the oper-
ating cycle must be taken into account (such as times in
II
which the power tool is switched off or time in which it is
switched on, but is not running under a load).
8. Unpacking
• Open the packaging and carefully remove the product.
• Remove the packaging material, as well as the pack-
aging and transport safety devices (if present).
• Check whether the scope of delivery is complete.
• Check the product and accessory parts for transport
damage. In the event of complaints the carrier must
be informed immediately. Later claims will not be
recognised.
• If possible, keep the packaging until the expiry of the
warranty period.
• Familiarise yourself with the product by means of the
operating manual before using for the first time.
• With accessories as well as wearing parts and re-
placement parts use only original parts. Spare parts
can be obtained from your specialist dealer.
• When ordering please provide our article number as
well as type and year of manufacture for the product.
m WARNING!
The product and the packaging material are not
children's toys! Do not let children play with plas-
tic bags, films or small parts! There is a danger of
choking or suffocating!
9. Start-up
m
WARNING
For you own safety, only insert the mains plug in an
outlet when all assembly steps have been completed
and you have read and understood the safety and op-
erating instructions.
m Attention!
Always make sure the product is fully assembled
before commissioning!
9.1 Assembling the machine
• Lift the machine out of the packaging with the help
of a second person.
• Move the rotary table to the 0° position and fit the
parallel stop (1).
GB | 41