Before Starting The Machine; Unpacking; General Notes - Scheppach DECO-XLS Bedienungsanleitung

*Operating mode S1:
Continuous operation at constant load
**Operating mode S6 30%:
Continuous operation with idling (cycle time 10 min-
utes). To ensure that the motor does not become ex-
cessively hot, it may only be operated for 30% of the
cycle at the specified rating and must then be allowed
to idle for 70% of the cycle.
Noise emission values
Sound
Sound values were measured in accordance with EN
61029.
Wear ear-muffs.
The impact of noise can cause damage to hearing.
Sound pressure level L .......................... 66,9 dB(A)
pA
Uncertainty K ............................................... 3 dB(A)
pA
Sound power level L ............................... 79,9 dB(A)
WA
Uncertainty K .............................................. 3 dB(A)
WA
The quoted values are emission values and not nec-
essarily reliable workplace values. Although there is
a correlation between emission and imission levels it
is impossible to draw any certain conclusions as to
the need for additional precautions.
Factors with a potential influence on the actual im-
mission level at the workplace include the duration of
impact, the type of room, and other sources of noise
etc., e. g. the number of machines and other neigh-
bouring operations.
Reliable workplace values may also vary from coun-
try to country. With this information the user should
at least be able to make a better assessment of the
dangers and risks involved.
Limit the noise level to a minimum!
• Use only equipment that is in perfect condition.
• Maintain and clean the equipment regularly.
• Adopt your way of working to the equipment.
• Do not overload the equipment.
• Have the equipment checked if necessary.
• Switch off the equipment when not in use.
Suitable saw blades
All industry-standard saw blades with a minimum
length of 127 mm with and without a pin may be used.

7. Before starting the machine

7.1 Unpacking

• Open the packaging and remove the device care-
fully.
• Remove the packaging material as well as the
packaging and transport bracing (if available).
• Check that the delivery is complete.
• Check the device and accessory parts for transport
damage.
• If possible, store the packaging until the warranty
period has expired.
ATTENTION
The device and packaging materials are not toys!
Children must not be allowed to play with plastic
bags, film and small parts! There is a risk of swal-
lowing and suffocation!

7.2 General notes

• All covers and safety devices have to be properly
fitted before the equipment is switched on.
• It must be possible for the blade to run freely.
• When working with wood that has been processed
before, watch out for foreign bodies such as nails
or screws, etc.
• Before you actuate the On/Off switch, make sure
that the saw blade is correctly fitted and that the
equipment's moving parts run smoothly.
• Check that the voltage on the rating plate is the
same as your supply voltage before you connect
the equipment to the power supply.
• Only ever connect the equipment to a properly in-
stalled shock-proof socket which is protected by a
10A fuse as a minimum.
7.3 Installing the fretsaw on a workbench
Required for installing:
Included in the scope of delivery:
• M8 hexagonal bolt (4x)
• M8 hexagonal nut (4x)
• Washer Ø 9 mm (8x)
The length of the screws to be used varies, depend-
ing on the thickness of the table top.
WARNING
Danger of injury! Disconnect the mains plug on the
scroll saw before all assembly work.
1. The length of the screws to be used varies, de-
pending on the thickness of the table top.
2. Mark the drill holes (see fig. 5.2).
3. Drill 4 holes with a diameter of 8 mm into the
work table.
www.scheppach.com
GB | 25