Storage; Troubleshooting; Possible Cause - Scheppach Temver St700C Originalbetriebsanleitung

17. Storage

• Store the device and its accessories in a dark, dry
and frost-free place that is inaccessible to children.
• Store the machine in the transport position.
• The optimum storage temperature lies between 5
and 30 ˚C.
• Cover the tool to protect it from dust or moisture.
• Store the operating manual with the tool.

18. Troubleshooting

Important note in the case of repairs:
For return delivery of the device for repair, please ensure for safety reasons that it is free of oil and fuel when it is sent to
the service centre.
Fault

Possible cause

The saw does not 1. Mechanical brake is defective.
brake when switch-
ing the machine off.
Saw blade is loose 1. Fixing nut not tight enough.
after the motor is
switched off.
Burnt areas on the 1. Blunt saw blade.
cutting surface. 2. Incorrect saw blade.
Engine does not 1. Mains fuse blown.
start. 2. Extension cable defective.
3. Connection to the engine or
switch not OK.
4. Motor or switch faulty.
Incorrect motor rota- 1. Capacitor defective.
tion direction. 2. Incorrect polarity /
Incorrect connection
Motor not supplying 1. Cross section of the extension
power, fuse tripping. lead insufficient.
2. Overload due to blunt saw blade.
Burnt areas on the 1. Blunt saw blade.
cutting surface. 2. Incorrect saw blade.
Saw blade jammed. 1. Switch the machine off and pull
out the mains plug
m Electrical maintenance work may only be carried out by a qualified electrician!
Remedy
1. Have the brake replaced.
1. Tighten fixing nut; right-hand thread (90Nm).
1. Sharpen saw blade (by a specialist).
2. Replace saw blade.
1. Check mains fuse.
2. Replace the extension lead.
3. Have this checked by an electrician.
4. Have this checked by an electrician.
1. Have this checked by an electrician.
2. Change direction of rotation with phase inverter / Have
an electrician change the polarity of the wall plug.
1. see "Electrical connection".
2. Replacing the saw blade.
1. Sharpen saw blade (by a specialist).
2. Replace saw blade.
1. Loosen the blockage.
GB | 25