Inhaltsverzeichnis
Werbung
Warnings, Cautions and Others
7
Precautions for installation
• Do not install the speakers on an uneven surface or in a place
subject to vibration; otherwise, they may fall over, causing
damage or injury.
– Take the occurrence of earthquakes or other
physical shocks into consideration when selecting
the installation place, and secure the speakers
thoroughly.
• To prevent deformation or discoloration of the
cabinet, do not install the speakers where they are
exposed to direct sunlight or high humidity, and
avoid installation near air conditioning outlets.
• Speaker vibrations may cause howling. Place the
speakers as far away from the player as possible.
• The speakers are magnetically shielded to avoid
color distortions on TVs. However, if not installed properly, it
may cause color distortions. So, pay attention to the following
when installing the speakers.
– When placing the speakers near a TV set, turn off the TV's
main power switch or unplug it before installing the
speakers.
Then wait at least 30 minutes before turning on the TV's
main power switch again.
Some TVs may still be affected even though you have followed
the above. If this happens, move the speakers further away
from the TV.
• Tuner reception may become noisy or hissing if a speaker is
installed near the tuner. In this case, leave more distance
between the tuner and the speakers or use an outdoor
antenna for better tuner reception without interference from
the speakers.
• Do not lean against the speakers, as the speakers could fall
down or break, possibly causing an injury. Especially be
careful that children do not lean against them.
7
Precautions for Daily Use
• To maintain the appearance of the speakers
Wipe with a dry, soft cloth if the cabinet or control panel should
become dirty.
If very dirty, apply a small amount of water or neutral detergent
to the cloth and wipe clean, then wipe with a dry cloth.
• To improve the sound field
If the speakers are facing a solid wall or glass door,
etc., it is recommended to furnish the wall with
materials that absorb sounds, for example by
hanging up thick curtains, to prevent reflections and
standing waves.
Speaker and Speaker cords—to improve the sound quality
About DD (Direct Drive) speaker
DD (Direct Drive) technology improves sound localization and transmits the powerful sounds.
About the OFC cord
The core wires of the supplied speaker cords are made of OFC (Oxygen Free Copper). This OFC cord enables high quality
sound reproduction.
When connecting the speaker cords
Make sure to match the polarity (ª and ·); otherwise, the surround effect will become less effective.
After connecting, check that the exposed cores are fully inserted into the terminal.
When using other speaker cords
Observe the following;
• Buy thick speaker cords rather than thin cords, and make them as short as possible for connection.
• Use speaker cords of the same length for both left and right speakers.
• Do not use long speaker cords; otherwise, the sound quality may deteriorate.
• To use the speakers without any trouble
– Do not reproduce sounds at so high a volume that they are
distorted; otherwise, the speakers may be damaged by
internal heat buildup.
– When moving the speakers, do not pull the speaker cords;
otherwise, the speakers may fall over, causing damage or
injury.
– When holding a satellite speaker, do not grasp the speaker
(upper) portion, but always grasp the leg (lower) portion of
the satellite speaker.
Leg
Satellite
speaker
7
Checking the supplied Accessories
Check to be sure you have the following supplied accessories.
The number in parenthesis indicates the quantity of the piece
supplied.
• Speaker cords
6 m (3);
For front left/right and center speakers
15 m (3);
For surround left/right and surround
back speakers
• Screws
(M5 x 12 mm) (5)
(M4 x 25 mm) (15)
• Washers
(5)
If any of the items above are missing, contact your dealer
immediately.
Speaker
grille
Speaker
cord
2
Werbung
Inhaltsverzeichnis
