Scheppach HM100T Originalbetriebsanleitung Seite 32

1. Introduction
Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer
We hope working with your new machine brings you
much enjoyment and success.
Note:
In accordance with the applicable product liability laws,
the manufacturer of this machine assumes no liability
for damage to the machine or caused by the machine
arising from:
• Improper handling
• Non-compliance with the operating manual
• Repairs carried out by third parties, unauthorised
specialists
• Installing and replacing non-original spare parts
• Improper use
• Failures of the electrical system due to failure to
observe the national electrical requirements and
regulations.
Note:
The operating manual is part of this product. It includes
important instructions for the safe, proper and econom-
ic operation of the product, for avoiding danger, for min-
imising repair costs and downtimes and for increasing
the reliability and extending the service life of the prod-
uct. In addition to the safety instructions in this operat-
ing manual, you must also observe the regulations ap-
plicable to the operation of the product in your country.
Familiarise yourself with all operating and safety in-
structions before using the product. Only operate the
product as described and for the specified areas of ap-
plication. Keep the operating manual in a good place
and hand over all documents when passing the product
on to third parties.
2. Description of the product
1. Parallel stop
2. Release button
3. On/off switch for circular table saw operation
4. Circular table saw
5. Handle
6. Sawing shaft lock
7. Engine
32 | GB
8. Cross-cut saw stop rail
9. Machine table
10. Mitre cut angle scale
11. Cross-cut saw table (rotatable)
12. Saw blade
13. Cross-cut saw table locking knob
14. Lower saw blade cover
15. Workpiece clamp
16. Workpiece holder screws
16a. Base screw
16b. Arm bolt
16c. Clamping screw
17. Moving saw blade guard
18. Locking screw for parallel stop
19. Dust bag
20. Locking pin
21. Swivelling device locking lever
22. On/off switch for cross-cut saw operation
23. Transverse stop
24. Stop rail star knob screws
25. T-slot rail star knob screw
26. Transverse stop angle scale pointer
27. Transverse stop angle scale
28. Push stick
29. 6 mm Allen key
30. 3 mm Allen key
31. Machine foot
32. Allen screw
33. Rubber foot
34. Nut
35. End stop screw
36. Locking nut
37. Upper saw blade cover
38. Riving knife
39. Stop rail
40. 90° tilt stop screw
41. Lock nut
42. Angled cut scale
43. Angle scale pointer
44. 45° tilt stop screw
45. Lock nut
46. Chip extraction nozzle
47. Screws (saw blade guard)
48. Circular saw table screws
49. Cross-cut saw table screws
50. Flange screw
51. Outer flange
52. Inner flange
53. Sliding fitting transverse stop
54. Lower saw cover marking
55. Cross-cut saw table angle pointer
www.scheppach.com