VEVOR RTADB-1 Bedienungsanleitung Seite 15

Installation Instructions
Step One:
Remove the cover of Wire controller box.
Step Two:
Secure the back cover with screws.
Step Three:
According to the drawing install two screws one by one.
Step Four:
Finally, the wire controller is buckled on the back cover and the installation is
completed
Remarks:
1. After powering off and powering on or abnormal communication returns to
normal, you need to re-operate the on-off button, or after setting the timing setting,
or after waiting for three minutes, you can directly operate and adjust.
2. The above pictures are for reference only, mainly in kind.
- 14 -