Plunge Cuts; Troubleshooting - Parkside Pstd 350 B1 Bedienungsanleitung Und Originalbetriebsanleitung

CAUTION! Risk of kickback and
m
personal injury!
Plunge cuts are very challenging and
u
are associated with a higher risk of
injuries. Only use this technique if you
are familiar with it.
˜ Troubleshooting
Problem
The product does not
work.
The product creates
rough or splintered
cuts.
There is excessive
vibration or noise.
The saw blade
8 ] [
is overheating or
burning wood.
The dust extraction
does not work.
Possible cause
The plug is not
2 ] [
connected to a mains
outlet.
The cutting is too
aggressive for delicate
materials.
The saw blade is
[ 8 ]
loose.
The workpiece is
moving.
The saw blade is
8 ] [
dull.
The cutting through
dense material is too
slow.
The dust extraction is
not setup correctly.
(Fig. D)
1. Place the front edge of the base
plate on the workpiece so that
[ ]
the saw blade
8 ] [
workpiece.
2. Switch the product on.
3. Slowly plunge the saw blade
workpiece.
4. When you have cut through the depth
of the workpiece, continue sawing as
usual.
Solution
Connect the plug
outlet.
Use a fine-toothed saw blade
o
Apply masking tape along the cut
o
line to reduce splintering.
Cut slowly to minimize the tear-out.
o
Insert the saw blade
"Inserting/removing the saw blade").
Tightly secure the workpiece with
the aid of clamping devices on the
workbench.
Replace the saw blade
"Replacement parts/Accessories").
Increase the cutting speed.
o
Avoid forcing the product.
o
Check the dust extraction (see
"Attaching/removing the dust
extraction").
does not touch the
into the
[ 8 ]
to a suitable mains
2 ] [
.
8 ] [
correctly (see
[ 8 ]
(see
8 ] [
GB/IE/NI/MT 15