Fitting Abrasive Belts; Adjusting The Working Depth; Milling Direction On Edges; Carrying Out Plunge Cuts - Parkside IAN 270700 Originalbetriebsanleitung

Fitting abrasive belts

GB
♦ Push the abrasive belt onto the abrasive belt
mandrel from above
the abrasive belt mandrel
abrasive belt
♦ Fit the abrasive belts
section "Replacing tools".

Adjusting the working depth

♦ Loosen the wing adjusting screw
♦ Push the footplate
working depth (around 3.2 mm more than the
material thickness for complete cutting). The
maximum recommended cut depth forward is
13 mm *(applies only to multipurpose milling
cutters (HSS)
♦ Retighten the wing adjusting screw

Milling direction on edges

Carrying out plunge cuts

♦ Introduce the bit into the workpiece at an angle
of 45°.
♦ Slowly change the angle of the bit to 90°
before starting the cut.
NOTE
► The baseplate
surface.
6
. Tighten the bolt on
in order to fix the
.
as described in the
.
down to the required
).
.
must be flush with the material

Swivelling the handle

NOTE
► Do not rotate the handle while working.
Remove the plug from the mains socket and
ensure that the swivel lock
Swivelling to the horizontal position:
♦ Press the swivel lock
♦ Rotate the handle anticlockwise
vertical to the horizontal position until the swivel
lock engages.
Swivelling to the vertical position:
♦ Press the swivel lock
♦ Rotate the handle clockwise
zontal to the vertical position until the swivel
lock engages.

Using the parallel guide

♦ Undo the wing screw
and push the guide rod on the circular/parallel
cutting attachment
on the bottom of the baseplate
parallel guide is facing downwards.
♦ Align the tool at the required distance from the
workpiece edge. Tighten the wing screws
order to fix the circular/parallel cutting attach-
ment to the baseplate

Sawing circles

NOTE
► Depending on the required results, the guide
hole is placed either on the inside or the out-
side of the circle circumference. Inside for
a hole – outside for a disc. The radius can
be fixed approximately between 5 to 16 cm.
♦ Draw a circle on the workpiece.
♦ Mark the centre of the circle and drill a hole in
it (plunge cut).
♦ Drill a guide hole on the outside of the circle
(plunge cut) (guide hole diameter 3 mm).
is engaged.
and hold it down.
from the
and hold it down.
from the hori-
on the baseplate ,
through the two recesses
so that the
in
.
PSFS 250 A1