Cleaning, Maintenance And Storage; Cleaning; Maintenance; Storage - Parkside Pwsa 20-Li D4 Originalbetriebsanleitung

4. Remove the rechargeable battery (13)
from the device if you are leaving the
device unattended or if you have finished
working.
Cleaning, maintenance and

storage

WARNING! Risk of injury due to unin-
tentional start-up. Protect yourself when
performing maintenance or cleaning work.
Switch off the device and remove the battery
(13).
You should have any repair and maintenance
work that is not described in these instruc-
tions carried out by our Service Centre. Only
use original replacement parts.

Cleaning

WARNING! Electric shock! Never spray
down the device with water.
NOTICE! Risk of damage. Chemical sub-
stances may attack the plastic parts of the
machine. Do not use any cleaning agents or
solvents.

Troubleshooting

The following table will assist you in fixing faults:
Problem
Device does not start
Attachment tool does not
move although motor is run-
ning
Engine is slowing down and
stops
Attachment tool does not
rotate smoothly, abnormal
noises can be heard
Device works with interrup-
tions
• Keep the ventilation slits, motor housing

Maintenance

The device is maintenance free.
Storage
Always store the device and accessories:
• clean
• dry
• protected against dust
• out of the reach of children
Devices with battery:
• The storage temperature for the bat-
• Remove the battery from the device be-
Storing cutting/grinding discs
• dry
• upright
• unstacked
Possible cause
Rechargeable battery (13) not
inserted
On/Off switch (3) defective
Defective motor
Clamping nut (22) loose
Workpiece, workpiece rem-
nants or remnants of attach-
ment tools blocking the drive
Device is overloaded through
workpiece
Clamping nut (22) loose
Attachment tool defective
Internal loose contact
On/Off switch (3) defective
GB
and handles of the machine clean. Use a
damp cloth or brush to do this.
tery and device is between 15 °C and
25 °C. Avoid extreme cold or heat during
storage to ensure the battery output is
not adversely affected.
fore storage over a longer period (see
separate operating instructions for battery
and charger).
Error correction
Inserting the battery, p. 16
Contact the service centre.
Contact the service centre.
Tightening the clamping nut
Remove blockages
Reduce pressure on attach-
ment tool
Workpiece unsuitable
Tightening the clamping nut
Changing the attachment tool
Contact the service centre.
IE NI CY
17