Koenic KRVC 2320 RC Gebrauchsanweisung Seite 27

Troubleshooting, indicated by audible signals of the robot
Voice signal of the robot Necessary action
The left wheel is hanging in the air Move the robot to a new position and restart the task
Lead brush is twined Remove dirt (e.g. long hairs) from the brush
The right wheel is hanging in the air Move the robot to a new position and restart the task
The left wheel is twined Remove dirt (e.g. long hairs) from the wheel
The right wheel is twined Remove dirt (e.g. long hairs) from the wheel
Because of the uneven ground Move the robot to a new position and restart the task
The side brushes are twined Remove dirt (e.g. long hairs) from the brushes
The speed sensor is abnormal Turn o the bottom power switch and restart after 5
minutes. If the fault cannot be discharged, contact your
retailer
The collision sensor is blocked Check the collision detection board for damages /
blockages
The dustbin has loosened Ensure that the dust bin is properly fastened to the
robot
The ground sensor is blocked Clean the sensor lens and restart it. If the fault cannot
be discharged, contact your retailer
Work Current detected abnormal Check the side brushes, wheels and roller brush.
Disposal
Do not dispose of this product as Please dispose of batteries in an
unsorted municipal waste. Return it to a environmentally friendly manner. Do not
designated collection point for the put batteries into the household waste.
recycling of WEEE. By doing so, you will help to Please use the return and collection systems in
conserve resources and protect the your community or contact the dealer where you
environment. Contact your retailer or local purchased the product.
authorities for more information.
IM_KRVC2320RC_190807_V10_HR.indb 27
English
27
7/8/2019 14:43