Koenic KRVC 2320 RC Gebrauchsanweisung Seite 24

Size - A5
English
Fig. 17 Insert the water tank into the vacuum Fig. 20 Remove the mop cover from the water
robot. tank and wash it with a little detergent
For operation, follow the instructions in and rinse it o. Wring the mop cover
the chapter Operating as a vacuum slightly and let it dry.
cleaner. The robot will automatically
return to the charging base, after the Fig. Attach the mop cover in the correct
21
cleaning process has been finished, or position on the water tank. A
if the battery level is low. Note, that replacement mop cover is included.
the water tank has to be removed
immediately to avoid damages to the Recommendations for a better
flooring. cleaning result
Note:
Vacuuming
•In order to enhance the wet cleaning result,
• Before starting the vacuuming process,
it is advised to vacuum the area prior to
remove all objects that stand/ lay on the
the wet cleaning, to remove dust and other
floor, which could interfere with the process
small residues.
or in which the robot could get tangled up
•Wet the mop for before each use.
(e.g. toys, carpets with longer cords etc.).
• Make sure that no objects hang down onto
the floor, in which the robot could get stuck
Attention
(e.g. power supply cables, curtains etc.).
Water will start to drip out of the
• If possible, place chairs on the table during
attachment, as soon as the water tank has
the vacuuming process, in order to minimize
been inserted. Start the cleaning process
the number of obstacles on the floor.
immediately after inserting the water tank,
• Block areas, in which the robot could get
so avoid possible damages to the floor. Due
stuck (e.g. closets with lowered boards,
to the same reason, remove the water tank
tapered areas in between closets etc.).
directly after the cleaning process has ended.
• Make sure that all brushes can rotate freely
Always supervise the product during the
and aren't blocked. Clean them if necessary.
cleaning, to prevent water damages to the
• Empty the dust container.
flooring, in case the robot should get stuck.
The supplier is not liable for damages, that
Swabbing
occur due to the negligence of all given
• Observe all recommendations listed above.
warnings and remarks concerning the usage
• Have the robot vacuum the area before
of the product as well as the cleaning of the
swabbing, in order to reduce the amount of
flooring.
dust on the floor.
• Soak the cleaning cloth under running water
Fig. After swabbing, remove the water tank
18 and slightly wring it out, before attaching it
with the mop cover. to the water tank, to enhance the cleaning
result and to achieve an equal distribution
Fig. Open the rubber cap and pour of water onto the floor.
19
remaining water out of the tank. • If necessary, pause the swabbing process
and manually wring out the cleaning cloth,
removing bigger particles, before continuing
the process.
24
IM_KRVC2320RC_190807_V10_HR.indb 24 7/8/2019 14:43