Koenic KRVC 2320 RC Gebrauchsanweisung Seite 21

Assembly Alternatively, for charging, the DC plug
of the charger can also be connected
Charging station directly to the DC socket on the vacuum
Fig. Insert the DC plug of the charger into robot.
1
the DC socket on the charging station.
Note:
Connect the power adaptor to the
• Make sure that the charging contacts of
mains.
the robot vacuum cleaner and charging
base are not dirty. Clean the contacts if
Fig. Place the charging station against the
2
necessary.
wall, so that the vacuum robot can return
• It is normal for the charging base and
to the charging station independently.
vacuum cleaner to become hot during
Pay attention to the required clearances
charging. This is not a cause for concern.
at the charging station.
• Remove the water tank before charging
the robot vacuum cleaner.
Note:
Remove any objects within 1 meter from
either side of the station and 2 meters from Fig. When the battery is charging, the on/
6
the front of the station. standby switch LED flashes blue. When
the battery is charged, the LED is on
Fig. Press the two rotary brushes labelled permanently.
3
L and R onto the brackets until they
click into place. Pay attention to the LED indicator
designation and L R on the device as
LED color Condition
well as the brushes..
Permanently blue Battery is fully charged
Blue flashing During charging
Indicator light o Product is switched o
Remote Control
Fig. Open the battery compartment on the Brush roller is blocked
4
Permanently red
back of the remote control. Insert two and has to be cleaned
AAA / LR03 batteries into the battery
Fig. If the old battery is worn, it can be
compartment. Observe the correct 7
replaced by a replacement battery (not
polarity (+/-) according to the imprint.
included in the delivery).
Remove the screws and the battery
Charging the battery
compartment cover and remove the old
Fig. Switch on the vacuum robot with the
5
battery. Insert the new battery in the
on/ o switch on the bottom (I) . Set it
down in front of the charging station. correct direction to the connector. Close
the battery compartment and tighten
Press the on/ standby switch on the
vacuum robot or the charging base the two screws.
button on the remote control and
then immediately the charging station
button. Make sure the robotic vacuum
cleaner is moving to the charging
station. Before first time use the
built-in batteries must be charged for
at least 12 hours. Subsequent charging
processes will take approx. 4-6 hours
when the battery is empty.
IM_KRVC2320RC_190807_V10_HR.indb 21
English
21
7/8/2019 14:43