Koenic KRVC 2320 RC Gebrauchsanweisung Seite 25

Cleaning and care
Fig. 25 Close the dust collector again and
insert it into the vacuum cleaner. Make
sure it is assembled properly.
Warning
• When cleaning, never use solvents or
Warning
abrasive materials, hard brushes, metallic
or sharp objects. Solvents are harmful to Never use the device without a filter
human health and can attack plastic parts,
while abrasive cleaning mechanisms and
Note:
tools may scratch the surface(s).
• The two rotating brushes are subject to a
• Never immerse any electrical part of the
certain amount of wear, depending on the
product in water or in other liquids during
type of hard floors you have (e.g. rough,
cleaning. Never place it under running
rustic tiles). Therefore, you must check
water.
them at regular intervals to ensure, that
• Before cleaning, always switch o the
they're undamaged.
vacuum robot and disconnect the plug of
• Worn rotating brushes may have sharp
the charging base from the power supply.
edges that can damage sensitive hard
floors, such as parquet or linoleum.
Emptying dust container and cleaning
The Imtron GmbH does not accept any
filters and mop cover
responsibility for damage caused by worn
Note: The dust container should be emptied brushes
every time after vacuuming.
Fig. If the brush roller is blocked by or full
26
Fig. 22 After vacuuming, remove the dust with hair, lint or similar residues remove
container. Press the release button and
and clean it. Press the buttons on the
pull it out. cap, remove the cap and then remove
the brush roller. Remove hair and
Fig. Hold the dust container over a dust bin,
23 lint, etc. by hand or with a brush. The
so that the opening with the yellow assembly takes place in reverse order.
flap faces upwards. This way, the dust
will fall downwards, when opening the
container.
Fig. 24 After approx. 3 operating hours, but
at the latest when the performance
decreases, clean the dust pre-filter, fine
filter and HEPA filter. To do this, remove
all filter components and clean them
separately. The assembly is done in
reverse order. Make sure, that the filter
insert is correctly assembled. To ensure
this, press the shorter side wall into the
fitting first, before pushing in the filter
on the other sides by pressing down on
the edges.
IM_KRVC2320RC_190807_V10_HR.indb 25
English
25
7/8/2019 14:43