Koenic KRVC 2320 RC Gebrauchsanweisung Seite 23

Set start time with timer Set mode
Fig. To start a cleaning process in your Fig. After starting a cleaning task, press the
13 14
absence, set a start time for cleaning. mode button on the remote control to
set the mode. Follow below table for an
Note: You must be near the robot vacuum
explanation.
cleaner with the remote control. If the blue
LED is o when the timer settings are
Operation as swab
completed (sleep/ standby mode), the start
time settings will not be applied. Note: To enhance the cleaning result and to
achieve an equal distribution of water onto
Set the on/ o switch to position and press I the floor, it is necessary to soak the cleaning
the on/ standby button on the unit or the start/ cloth under running water and slightly wring
pause button on the remote control. The device it out, before attaching it to the water tank.
is now activated. Press the timer button to set This enhances equal flow of water from the
the start time. water tank through the cleaning cloth.
The hour indicator flashes. Use the arrow keys
to set the hours. Then press the arrow Fig. Remove the dust collector. To do so,
15
key to set the minutes display. press the release button and pull it out.
The minute display flashes. Use the arrow
keys to set the minutes. Fig. Open the rubber cap and fill the water
16
Confirm your entry by pressing the timer tank as desired, but not above the MAX
button. An acoustic signal sounds and indicates mark. Close the cap again. Make sure
that the vacuum cleaner has been successfully the mop cover is attached correctly.
pre-programmed. Attention! Do not use harsh or
The LED of the control lamp flashes. At the set corrosive cleaners or additives. Note,
time, the cleaning process starts. that the addition of detergents might
To deactivate the start time, press the Timer impair the traction of the product and
button for approx. 3 seconds. The timer symbol hence negatively influence the cleaning
in the display o the remote control turns o. result. It is recommended to use pure
water only for cleaning. Always observe
the cleaning recommendations and
requirements of the suppliers of the
flooring. Consult the supplier in case of
doubts or uncertainties.
Mode Symbols Explanation
Standard mode • Standard cleaning, areas and edges are
-
cleaned alternating
Powerful cleaning • Powerful cleaning, the vacuum cleaner is
+
moving spirally
Corners and edges cleaning • The vacuum cleaner is cleaning along edges
+
and around obstacles.
Areas • The vacuum cleaner is cleaning areas and
+
moving in parallel lines
IM_KRVC2320RC_190807_V10_HR.indb 23
English
23
7/8/2019 14:43