Novoferm tormatic T100 R-FU 1,5kW Montage- Und Betriebsanleitung Seite 32

Menu 6 Radio
Menu Entry Selection
item
60 Programming the start button on the hand-held trans-
mitter
61 Programming the 1/2 opening button on the hand-
held transmitter
62 Programming the light button on the hand-held trans-
mitter
63 Deleting radio codes
Press for 5 s
64 Hand-held transmitter operating mode
0 off
1 Pulsed operation open/stop/close
2 Automatic closing AR (default setting)
3 Open-close operation
- - Exit menu
Menu 7 FU settings
Menu Entry Selection
item
70 Opening speed
0-99 1 % - 100 % of motor speed
71 Closing speed
0 - 99 1 % - 100 % of motor speed
72 Soft run mode
0 - 99 1 % - 100 % of motor speed
73 Acceleration time open
0 - 39 0.1 s – 4.0 s
74 Braking time open
0-39 0.1 s - 4.0 s
75 Acceleration time close
0 - 39 0.1 s - 4.0 s
76 Braking time close
0 - 39 0.1 s - 4.0 s
77 Soft run mode (number of motor revolutions)
0 - 9 Only before 'close' end position (0 - 9)
10 - 19 Before 'open' and 'close' end position (0 - 9)
20 - 29 Only before 'open' end position (0 - 9)
78 Motor brake
0 - 9 Type A, door closing delay (0 - 350 ms)
10 - 19 Type B, door closing delay (0 - 350 ms)
30 - EN
Menu 7 FU settings
Menu Entry Selection
item
79
0 No drive motor selected (default setting)
1 Novo Speed Flex motor
2 SE 9.20
3 SE 9.24
4 SE 14.21
5 SE 6.115
6 SI 14.80
7 SI 20.90
8 SI 30.46
9 SI 5.250
10 SE 3,5.120
11 TD 2.60.180
12 SI 35.60
13 TD 2.65.142 (DES 20:1)
14 TD 2.65.142 (DES 15:1)
15 SI 35.30
16 SI 65.24
17 TD 2.75.120
18 SI 8.180
19 SI 12.90
20 SI 35.60 (Helix 3x400 V star connection)
21 SI 13.60
22 SE 6.65
23 SE 14.50
24 SI 17.50
25 SI 25.60
26 SI 50.24 (3x400 V star connection)
27 SI 8.240
28 SI 5.240
- - Exit menu
T100 R-FU 1,5kW
Drive selection