After Finishing Work; Transporting - Stihl Rm 2.2 R Gebrauchsanleitung

English
► Hold the handlebar with both hands so the
thumbs enclose the handlebar.
11.2 Selecting the cutting height
4 different cutting heights can be selected:
– 30 mm = Position 1
– 50 mm = Position 2
– 70 mm = Position 3
– 85 mm = Position 4
The cutting height is set separately at the front
and rear. The cutting height setting must be iden‐
tical at the front and rear.
Setting the rear cutting height
► Shut off the engine.
The cutting blade must not be turning.
► Place the lawn mower on a level surface.
► Press the rear axle (1) downward.
The rear axle is released and can be adjusted.
► Move the rear axle (1) into the desired position
on the left and right.
Setting the front cutting height
► Shut off the engine.
The cutting blade must not be turning.
► Place the lawn mower on a level surface.
► Press the front axle downward.
The front axle is released and can be adjus‐
ted.
► Move the front axle into the desired position
on the left and right.
11.3 Mulching
In the mulching mode, the grass clippings are
recirculated in the airstream in the cutting blade
range, recut several times and then blown back
26
onto the lawn. The cuttings remain on the lawn
surface where they decompose quickly and
serve as a natural fertilizer. To maintain a beauti‐
ful, thick lawn, mulch regularly and remove one
third of the grass height.
Prerequisites for good mulching results:
– Frequency: At least twice a week in the spring
(main period of growth) and once a week in
the summer and fall.
– If possible, mow the lawn when it is dry.
– Use well sharpened cutting blades.
– Select a low mowing speed.
– Vary the mowing direction and make sure to
overlap the mowing strips.
– Mow very high grass multiple times.
► Push the lawn mower forward slowly and in a
controlled manner.

12 After Finishing Work

12.1 After Finishing Work
► Stop the engine.
► If the lawn mower is wet: allow the lawn
mower to dry.
► Clean the lawn mower.

13 Transporting

13.1 Transporting the lawn mower
► Shut off the engine.
The cutting blade must not be turning.
► Pull off the spark plug boot.
Pushing the lawn mower
► Push the lawn mower forward slowly and in a
controlled manner.
12 After Finishing Work
0478-111-9978-A