Using The Cooling Device; Latching The Cooling Device Lid - Dometic Cff12 Bedienungsanleitung

EN Dometic CFF
The battery monitor mode can be selected as follows:
1. Switch on the cooling device.
SET
2. Press the button three times.
For dual zone cooling devices, press the
+ –
3. Use the or buttons to select the battery monitor mode.
The display shows the selected mode for a few seconds: Lo (LOW), Nd (MEDIUM), Hi (HIGH)
The display flashes several times before it returns to the current temperature.
NOTE When the cooling device is supplied by the starter battery, select the battery monitor mode
"HIGH". If the cooling device is connected to a supply battery, the battery monitor mode "LOW" will
suffice.
9.5

Using the cooling device

NOTICE! Risk of overheating
Ensure at all times that there is sufficient ventilation so that the heat that generated during operation can
dissipate. Ensure that the ventilation slots are not covered. Ensure that the device is sufficiently far away
from walls and other objects so that the air can circulate.
NOTICE! Damage hazard from excessively low temperature
Ensure that only those objects are placed in the cooling device that are intended to be cooled at the
selected temperature.
NOTICE! Damage hazard
Place the cooling device as shown (
different orientation, it can be damaged.
NOTE When operating with the battery, the display switches off automatically if the battery voltage is low.
The LED flashes orange.
Before first use on page 11
1. Place the cooling device on a firm foundation.
2. Connect the cooling device (see
3. Press the button for between one and two seconds.
The LED lights up.
The display ( Fig. 
The cooling device starts cooling the interior.

Latching the cooling device lid

NOTE
CFF35, CFF45: When latching the lid, ensure that both latch side pins are fully engaged to ensure a
good lid seal. One latch may engage slightly before the other.
If the lid is not closed equally at both sides, press until a second click is heard.
18
SET
button four times.
Fig. 
Connecting the cooling device
on page 10 4) switches on and shows the current temperature.
on page 6 1). If you operate the cooling device in a
on page 17).