Installing An External Alarm; Using The Refrigerator; Energy Saving Tips - Dometic MC Series Montage- Und Bedienungsanleitung

Using the refrigerator

6.6

Installing an external alarm

Use the floating contacts at the back of the device as follows:
The upper contacts correspond to the power fail alarm (fig. 9 1 and 2, page 7).
•
The lower contacts correspond to the temperature alarm (fig. 9 3 and 4,
•
page 7).
A voltage between 12 V and 250 V can be connected at the contacts. The maximum
load must not exceed 8 A. The minimum power rating is 100 mA/5 V.
I
NOTE
The external alarm signal can only be switched off by eliminating the
cause of the alarm.
7 Using the refrigerator
I
NOTE
•
Before starting your new refrigerator for the first time, you should
clean it inside and outside with a damp cloth for hygienic reasons
(please refer to the chapter "Cleaning and maintenance" on
page 22).
•
Always leave some space between the mother milk containers in the
refrigerator to ensure efficient and even cooling. If the drawers are
packed too tightly there may be unacceptable temperature values.
•
Keep these operating instructions ready at hand and leave them with
the device, so that all users can find out about the functions and
safety regulations.
7.1

Energy saving tips

•
Choose a well ventilated location which is protected from direct sunlight.
•
Do not open the refrigerator more often than necessary.
•
Do not leave the doors open for longer than necessary.
•
Defrost your refrigerator as soon as a layer of ice forms.
18
MC302, MC502
EN