Whirlpool PACW9COL Gebrauchsanweisung Seite 21

STARTING YOUR LOCAL
AIR CONDITIONER
This section explains proper local air conditioner
operation.
IMPORTANT:
• The air conditioner display shows the setting
temperature.
• Only in standby mode the display shows the
ambient temperature
• When changing modes while the air conditioner
is operating, the compressor will stop for 3 to 5
minutes before restarting.
If a button is pressed during this time, the
compressor will not restart for another 3 to 5
minutes.
• In Cooling or Dry mode, the compressor and
condenser fan will stop when the room
temperature reaches the set temperature.
NOTE: In the event of a power failure, your air
conditioner will operate at the previous settings
when the power is restored.
1. Select the mode. See "Mode."
2. Select the fan speed. See "Fan Speed."
3. Set the temperature. See "Temperature."
4. Press ON/OFF button to start the air
conditioner.
HEAT
NOTE: When the air conditioner is turned on for
the first time after it is plugged in, it will run in the
6th Sense Mode control.
When the air conditioner is turned on at all other
times, it will run according to the previous settings.
6th Sense Mode can be selected with the remote
control only.
Only if the unit is operated in UNLIKELY VERY
HUMID air, water will be collected in the
container inside the unit. If the water container is
full, the air conditioner will stop. The water
container is full, the air conditioner will stop. The
screen will display "E5" to inform you to empty the
internal container.
21
FILTER