Whirlpool PACW9COL Gebrauchsanweisung Seite 31

INSTALLATION INSTRUCTIONS
Unpack the Air Conditioner
Remove packaging materials
• Remove and dispose of/recycle packaging materials. Remove tape and glue residue from surfaces before
turning on the air conditioner. Rub a small amount of liquid dish soap over the adhesive with your
fingers. Wipe with warm water and dry.
• Do not use sharp instruments, rubbing alcohol, flammable fluids, or abrasive cleaners to remove tape or
glue. These products can damage the surface of your air conditioner.
Install Local Air Conditioner
Install Exhaust Hose and Adapter
1. Open the window.
2. Measure the window opening.
• If the window opening is too narrow for the
window slider kit, remove the inner slider from
the window slider kit.
A.Inner slider section
B.Outer slider section
• Using a saw, cut the inner slider section to fit
the window opening.
• Slide the inner slider section into the outer slider
section of the window slider kit.
3. Place the window slider kit into the window,
extending it to fit the width of the window. Be
sure the rain cover is on the outside of the
window.
NOTE: For casement window installation, the
window slider kit may be installed vertically with
the window slider kit opening at the bottom.
4. Use a special plastic device with spring to fix the
window brackets: Place the device to the
position A, the pin may stretch out then lock the
brackets, when place the device to position B,
the pin will draw back and the brackets will be
released the window slider kit.
position B
5. Close the window onto the window slider kit to
secure.
A To local air conditioner
B Outdoors
C Rain cover
D Window slider kit
E Window exhaust adapter
F Flexible exhaust hose
31
position A