Whirlpool PACW9COL Gebrauchsanweisung Seite 26

Jet mode
Jet button is used for fast cooling or heating.
NOTE: 6th Sense mode button does not operate
when Jet function is selected.
1. Press Jet in cooling mode. The air conditioner
automatically sets the fan speed and the
temperature to 18°C. Fast heating operates at auto
fan speed, changing the set terperature to 32ºC.
Je t
2. To exit Jet mode press any button except Timer
Around U and Swing button.
Fan Speed
1. Choose desired fan speed.
2. Each time the "FAN" button is pressed, the fan
speed is changed in sequence:
Auto → High → Mid → Low
↑
• Auto-automatically controls fan speed depending
on current room temperature and temperature
control setting.
NOTE: Auto fan speed cannot be selected in Fan
Only mode.
• High - for maximum cooling
• Mid - for normal cooling
• Low - for minimum cooling
Temperature
• Press the UP adjust button to raise the
temperature. Press the UP Adjust button once
to increase the set temperature by 1ºC, or press
twice to increase the set temperature by 2ºC.
• Press the DOWN adjust button to lower the
temperature. Press the DOWN adjust botton to
decrease the set temperature by 1ºC, or press
twice to decrease the set temperature by 2ºC.
NOTES:
• In the Cooling or Heating mode, the
temperature can be set between 18ºC and
32ºC.
• In Fan Only mode, the temperature cannot be
set.
• In Dry mode, press the UP/DOWN botton the
set temperature change by 2ºC.
Around U function
When you press this button,the remote control
transmits signal of the actual room temperature
around it to the unit, and the appliance will
operate according to this temperature to let you
feel more comfortable.
Please keep the remote control in a location
where it can transmit the signal to the unit
properly. Press once to set and press again to
cancel.
Sleep mode
Press Sleep button on remote control and the
indicator in LCD lights up, the appliance operates
in sleep mode and the fan speed is automatically
set to low speed.
NOTES:
• The appliance will stop operation automatically
after operating for 8 hours.
• Fan speed is automatically set at low speed..
• In Cooling mode if the current room
temperature is below 26ºC, the temperature
will automatically increase 1°C during the first
hour after Sleep control is activated, then
remain the same.
• In Heating mode, the setting temperature will
decrease by 3ºC at most for 3 hours constantly,
then keeps steady.
26