ATOMSTACK A70PRO Benutzerhandbuch Seite 40

03. Observe the error between the position of the mark and the cross
laser, if there is an error, proceed to the next step of calibration
04. Click the up, down, left, and right buttons to move the cross laser
light as close as possible to the mark position (error value <1mm),
and click "CONFIRM" after calibration
( A ) How to set "Auxiliary positioning" function in LightBurn:
01. Find "Window" in the top navigation bar, and enable "Console"
function in the drop-down menu
Connect the touch screen controller to the control board with the con
02. Select any custom button, right click mouse to pop up the
button setting page, enter the name of the button in "Button Label",
enter [ESP501] under "Macro contents"
04
05
38
03
02
01