ATOMSTACK A70PRO Benutzerhandbuch Seite 33

06. File Name
07. Start
08. Auto Focus: Click the "Start" button, the laser module moves to the center of the screen for automatic focus,
and starts engraving after the focus is completed
09. Preview border: After clicking this button, the laser module will move around the edge according to the size of the engraved pattern
(the cross laser point represents the position of the preview border)
10. Move to center: Click this button, the laser module goes to the center point of the engraved pattern
11. Set bottom left: Set the current position of the laser module as the bottom left initial position
12. Set as center: Set the current position of the laser module as the center point of the pattern
13.14.15.16. Click the top-left button, the laser module goes to the upper left corner of the engraved pattern. Same for other buttons.
17.18.19.20. Control the laser module to move up, down, left and right, long press to move continuously
21. Home: The laser module returns to the origin no matter where it is
22. Coordinate values of X-axis and Y-axis
31