ATOMSTACK A70PRO Benutzerhandbuch Seite 31

4. Determine the engraving position.
4.1 Set the current position as the starting point for engraving.
4.2 Click the "Outline Scan" button, and the laser will begin scanning the outer contours of the pattern on the computer. You can change the
position of the engraving object based on the scanned outer contours. Additionally, you can click the "Surround" button multiple times until the
outer contour is in the desired engraving position.
1 2
5. Start and stop engraving.
Start
Stop
29