ATOMSTACK A70PRO Benutzerhandbuch Seite 20

Machine introduction
AUTO FOCUS: Press the switch, the laser autofocuses at the current position.
ALARM：When the limit switches are triggered , flames or tilting are detected, an alarm is activated.
USB DRIVE：Insert USB flash drive to update firmware or run the engraving file offline
RESET：Restart the engraver
SCREEN：Connect the touch screen controller to the control board with the control screen cable.
COMPUTER：Connect the control board to PC with the Type C cable, when running files with Lightburn or LaserGRBL
INPUT-24V：The engraver power input
OUTPUT-12V：Output 12V DC power supply for air assist，connect the air assist to the control board with the air assist power cable
INPUT-36V：Connect the 36V output terminal of the power supply. It is mainly used to power the laser.
AUTO FOCUS
ON/OFF
USB DRIVE
ALARM
RESET
18
SCREEN
COMPUTER
INPUT-24V
OUTPUT-12V
INPUT-36V