Num'axes PROTECTION PIE1150 Gebrauchsanleitung Seite 39

Trigger time
Time Lapse
Operating time
Camera name
Password
Timestamp on photos
Networks
Bluetooth
Power supply
External power supply
Stand-by time
Temperature
Humidity
Watertightness
Dimensions
Weight
12. Troubleshooting
12.1. The photos do not capture subject of interest
− Check the PIR sensitivity parameter setting. In warm environmental conditions,
set the sensor sensitivity to "High" and in cold weather use, set the sensor
sensitivity to "Low".
− Try to set your camera up in an area where no heat sources are in the camera's
field of view.
− In some cases, setting the camera near water will make it take images with no
subject in them. Try aiming the camera over ground.
− Avoid setting the camera up on small trees that are prone to being moved by
strong winds. Try to set the camera on stable and immovable objects, i.e., large
trees.
− Remove any limbs which are right in front of the camera lens.
− At night, the PIR sensor may detect beyond the range of the infrared flash.
Reduce the detection distance by adjusting the PIR sensor sensitivity.
Approx. 0.4 seconds
Programmable
Programmable
Programmable
Programmable
Date, time, lunar phase, ambient temperature, camera
name (if user programmed one)
Works with the 2G, 3G and 4G networks
Bluetooth 4.2 BLE: 2400-2483,5 MHz
@ 2 dBm EIRP max
8 x AA alkaline, lithium or rechargeable Ni-MH
batteries
6V/2A
Approximately 3 months
Operation: -20°C to +60°C
Storage: -30°C to +70°C
5% - 90%
IP66
135,5 x 103 x 70 mm
290 g (without batteries) | 470 g (with batteries)
Guide PIE1150 – Janvier 2026 – ind. A - 39/164