Battery Maintenance; Seasonal Maintenance; Winter Storage - Ecovacs Goat O600 Rtk Betriebsanleitung

6

Battery Maintenance

• For long-time storage, it is recommended to charge GOAT every 6
months� The Limited Warrant does not cover battery damage caused by
over-discharge�
• The battery CANNOT be charged when the ambient temperature is
above 40°C/104°F (O800 RTK) and 45°C/113°F (O600 RTK) or below
5°C/41°F(O800 RTK and O600 RTK)�
• The recommended temperature for GOAT operation is between
5-40°C/41~104°F(O800 RTK and O600 RTK)�
• The storage temperature range is -20-75°C/-4~167°F (O800 RTK and
O600 RTK)�
Note: The life-span of GOAT's battery depends on the frequency of usage and the
total hours of use� It is not separately rechargeable and must be charged through
GOAT� DO NOT dispose of disused or faulty batteries casually� Check with your
Local Authority for advice�
EN 30

6.3 Seasonal Maintenance

Winter Storage

1
GOAT
1� Power off your GOAT after it is fully charged�
2� Clean it thoroughly�
3� Store it with water-proof and dust-proof coverings in a cool, well-
ventilated, and dry place indoors�
Charging Station and RTK Reference Station
1� Unplug the Power Supply from the power socket�
2� Disconnect Power Supply from the Charging Station�
3� Mark the spot where you set the Charging Station and the RTK
Station for reference in the new working season�
4� Store the Stations, the Power Adapter, and cables in a cool, well-ven-
tilated, and dry place away from direct sunlight�
Note: It is necessary to put both Stations in the original position for working in a
new season� Otherwise, it may lead to location faults or map invalidation�
2 Spring Restart
1� Remove all coverings from your GOAT and the Stations�
2� Assemble both Stations, putting them back to where they were in the
last working season�
3� Check the cables for any damage or breaks and repair or replace as
needed� Connect the cables that are safe and qualified to use�
4� Check the Blades for sharpness and replace them if necessary� Refer
to the Maintenance section of this manual for detailed steps and tips�
5� Power on your GOAT and test if it is connected to the App and works
properly�