ECOVACS GOAT O600 RTK Betriebsanleitung Seite 16

3.2 Station Installation
1 Install the Charging Station
1� The specific range will be formed around the Charging Station
installation site(as shown in the figure), and it needs to meet the
following conditions .
• Strong Wi-Fi signal coverage
• Flat and open area without slopes
• No obstacles around the Charging Station
• Precut the grass around the Charging Station to a height< 6 cm(2�36")
6 cm (2.36")
2� Connect the longer cable to the Power Adapter� Please align the
notch (A) with the groove (B) and screw the nut until they are locked into
each other�
Note: The Charging Station has two cable ports: the longer one is for the Power
Adapter and the short one is for the RTK Reference Station�
EN 16
A
B
3� Connect the Charging Station Plug to the power supply and ensure
the blue light is steady on�
Note:
• Please ensure the Power Adapter is positioned 30 cm
the ground to prevent water and moisture damage�
• Please plug the device into an indoor outlet or an outdoor waterproof
outlet�
• You can choose to buy the extension cable by connecting it to the
power interface if needed�
4� If you want to fix the Charging Station to the ground, use the
Charging Station Fastening Anchors and the Allen key�
Note: You may want to do this after you have settled down everything�
(11�8")
30 cm
(11.8 )
"
above