blum SERVO-DRIVE Montageanleitung Seite 33

• Only 1 Blum transformer can be connected to each distribution cable�
• Maintain safety distances to the Blum transformer listed in the installation instructions�
• Make sure that moisture cannot penetrate the Blum transformer and drive unit�
• Before starting repair or maintenance work, unplug the Blum transformer to disconnect the
power�
• The drive unit, Blum transformer and SERVO-DRIVE switch should only be cleaned with a moist
cloth because penetrating moisture and aggressive cleaning materials can damage the electron-
ics�
• Do not touch the area around the lever during the opening and closing motion�
• No damaged parts should be used�
• Sharp edges may damage the cable�
• Neither the Blum transformer nor any cabling should come into contact with moving parts�
• Never take apart a drive unit or a SERVO-DRIVE switch�
WARNING
Danger of electric shock
➢ Never open a Blum transformer�
WARNING
There is a danger of injury if the lever springs upward.
There is a danger of injury from the lever springing upwards when the front is
removed�
➢ Do not push down on lever arm, instead, remove the arm if it is in the
way (not possible on HK variant)�
➢ Do not connect the transformer to the power supply while the fronts are
unattached�
EN
5