Using The Installation Instructions; Intended Use; Safety - blum SERVO-DRIVE Montageanleitung

Using the installation instructions

Please read the installation instructions and safety information before SERVO-DRIVE installation�
We recommend that you use the orientation diagram for easier identification of the parts being de-
scribed�
These installation instructions apply to the SERVO-DRIVE electrical motion support system for:
- the lift systems AVENTOS HF, AVENTOS HS, AVENTOS HL and AVENTOS HK
- the box systems LEGRABOX and TANDEMBOX as well as the runner systems MOVENTO and
TANDEM
However, only AVENTOS HF is used as an example in the illustrations�
Please see the special AVENTOS installation instructions for the assembly steps for the mechanical
AVENTOS HF, HS, HL and HK lift systems without SERVO-DRIVE�

Intended use

SERVO-DRIVE supports the opening and closing of lift systems and/or the opening of pull-out ele-
ments, and may only be used under the following conditions:
• In dry, enclosed rooms�
• In combination with AVENTOS lift systems and/or pull-out systems from Julius Blum GmbH within
permitted technical specifications�
• In combination with a Blum transformer�

Safety

SERVO-DRIVE complies with current safety standards�
Nevertheless, there are certain risk factors if these installation instructions are not followed� Please
be aware that Julius Blum GmbH is not responsible for incidental or consequential damages that may
arise due to non-compliance with these installation instructions�
• All national standards must be followed for SERVO-DRIVE assembly� This includes, in particular,
those related to the mechanical safety of moving parts and electrical cabling�
• Only qualified technicians may install/replace Blum components, modify the position of the Blum
transformer or modify any cabling�
• The device may only be connected to a power supply that corresponds to the type and frequency
listed on the serial tag (see Blum transformer)�
• The outlet must be freely accessible�
4 MA-502