Push-Button Function; Led Indication - Honeywell AXS4Secure Montage, Anschluss, Anleitung

32
8.

Push-button function

Push-button "REVISION"
All messages are cleared when the revision button is pressed.
Thus a tamper message is suppressed until the housing is closed.
Procedure:
- Press the revision button.
- Close the control panel door within 20 seconds.
- The clearing operation takes place. The control panel is ready
for use.
Push-button "ABORT"
Process data (main zone conditions etc.) are stored in the Flash EPROM.
The "ABORT" button must be pressed before the control panel can be switched powerless.
This process corresponds to a controlled system shutdown.
9.

LED indication

LEDs Ethernet:
LED 1 (green):
Blinking
Permanent On
LED 2 (green):
Permanent Off
Permanent On
LED 3 (yellow):
Permanent Off
Permanent on
LEDs Status information:
LED 4 (yellow):
LED 5 (green):
Blinking slow
Blinking fast
Permanent On
LED 6 (yellow):
LED 7 (green):
Blinking
Permanent On
-> Data transfer active
-> Ethernet connection ok
-> Data transfer rate 10 MBit/sec
-> Data transfer rate 100 MBit/sec
-> Transfer mode half-duplex
-> Transfer mode full-duplex
-> Initialization in progress
-> Not programmed
-> No or invalid license
-> Operation / Initialization successful,
programmed
no function
-> Firmware update in progress
-> Abort active (after the "ABORT" key
is pressed, the LED will remain lit till
the operating voltage can be discon-
nected.
Mounting and Connection Instructions AXS4Secure
ABORT REVISION
Ethernet (10/100)
LEDs Ethernet
LED1
LED2
LED3
LEDs status information
LED4 5 6 7