Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
6.9. Checking Continuity
Follow these steps to check a circuit's continuity.
-
+
1. Set the rotary selector to
2. Plug the black test lead into your meter's COM terminal and
the red test lead into your meter's V//Hz/-terminal.
3. Remove power from the circuit.
4. Connect the test leads to the circuit.
Note:
The buzzer sounds if the measured resistance is below about
30 approximately.
Warning!
Never perform a continuity measurement on a circuit that has
power connected.
-66-
Werbung
Inhaltsverzeichnis
