Herunterladen Inhalt Inhalt Diese Seite drucken

Etendue De La Livraison; Mise En Service; Mise En Place/Remplacement Des Piles - Conrad POCKET Com PMR Profi Bedienungsanleitung

Handfunkgerätes
Inhaltsverzeichnis

Werbung

• Switch the Pocket Com PMR Pro on.
• Use the UP/DOWN key to select one of the two channels which
you want to monitor.
• Press the "F" key (6) several times until the legend "DW" (DW
menu) appears on the display.
• Then select the second channel by using the "UP" or "DOWN"
key. The second channel is accepted after roughly 1 second and
two-channel monitoring starts.
As soon as there is a received signal in one of these channels
which exceeds the previously set "auto squelch" threshold, the
walkie-talkie locks into this channel and you can hear the received
signal. If the signal disappears for a prolonged period, the walkie-
talkie switches back and forth between the two previously set
channels.
To stop two-channel monitoring, briefly press the "ENTER" key or
switch the device off and on again.
Storing and retrieving channels
You can use the keypad to assign channels to 9 storage locations
as required.
Store
• Switch the Pocket Com PMR Pro on.
• Press the "F" key (6) until "M" appears on
the left centre of the display and "1" flashes
on the left display below the "M".
• Use the "UP" or "DOWN" key to select the
desired storage location (from 1 to 9) in
which the channel is to be stored.
54

Etendue de la livraison

• Pocket Com PMR Profi avec mode d'emploi
• clip de ceinture
• passant de portage

Mise en service

Avant toute mise en service, il est impératif de res-
pecter, à la fois, l'utilisation conforme à la destinati-
on du produit, les consignes de sécurité et les ca-
ractéristiques techniques.
Retirer
l'émetteur-récepteur
portable Pocket Com PMR
Profi de son emballage.
Examiner l'extérieur de l'ap-
pareil pour vérifier qu'il n'a pas
subi de dommage.

Mise en place/remplacement des piles

Ouvrir le logement des piles
(13) au dos de l'appareil.
Placer trois piles rondes de ty-
pe mignon (type AA) dans le lo-
gement des piles en respectant
Attention !
Ne pas laisser traîner négligem-
ment l'emballage. Le matériel
d'emballage n'est pas un jouet.
Il y a un risque d'étouffement,
en particulier avec des sachets
en plastique.
Tenir compte du fait que le ray-
on d'action maximal ne peut
être atteint qu'avec des piles
neuves ou, le cas échéant, des
accus entièrement rechargés.
Si l'appareil n'est pas utilisé
71

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis