Parkside Performance PASSP 20 Li C4 Bedienungsanleitung/Originalbetriebsanleitung Seite 45

˜ Belt clip
CAUTION! Risk of injury!
m
Before hanging the product on a
u
belt: Push the rotational direction
s itch [ 2 ] to the middle position.
This prevents the product from being
switched on accidentally.
Hanging the product on a belt: Use the
o
belt clip .
6 ] [
You can use the belt clip
o
opener for bottles with crown caps.
˜ Working instructions
NOTICE!
m
u Always follow the manufacturer's
instructions for tightening screws
or nuts. Follow the manufacturer's
guidelines for the inspection of
screws or nuts in accordance with
time or performance.
After changing a vehicle s heel s
u
Inspect the wheel bolts or nuts as
requested in the manufacturer's
instructions or guidelines. Tighten
the wheel bolts or nuts with a torque
rench after approx. 0 to 100 km.
The tightening torque depends on the
o
impact duration.
In order to achieve optimum impact
o
force, do not exert any pressure
against the screw/nut.
Only use the product to tighten screws
o
and nuts for pre-assembly work. It
is not the product that achieves the
desired target torque of the screw or
nut, but a torque wrench that is set to
the target torque.
Check the tightening torque actually
o
achieved with a torque wrench.
44 GB/IE
˜ Transport
o
o
o
˜ Cleaning, maintenance and
6 ] [ as a bottle
m
u
u
o
˜ Cleaning
m
u
m
u
o
˜ Maintenance
o
S itch o the product and remove the
battery pack 7 ] [ . Let all moving parts
come to a complete stop.
Remove the insertion tool.
Always carry the product by the
handle [ 3 ] .
storage
WARNING! Risk of injury due to
i i
Protect yourself when performing
maintenance or cleaning work.
S itch o the product and remove
the battery pack [ 7 ]
Have any repair and maintenance
work that is not described in these
instructions carried out by our Service
Centre see "Service" . Only use
original replacement parts.
WARNING! Risk of electric shock!
Never spray the product with water.
NOTICE! Risk of product damage!
Chemical substances may attack the
plastic parts of the product. Do not
use any cleaning agents or solvents.
Keep the ventilation slots, motor
housing and handle of the product
clean. Use a damp cloth or brush to
do this.
The product is maintenance free.
‑
.