Back Height Adjustment - Thomashilfen Hercules Prime R129 Gebrauchsanweisung

Instructions for Use – Hercules Prime R129
7.1.2 Folding up
First remove the two pelvic pads on the left and right. This prevents the pads from
being squeezed. Then release the red eccentric levers on both sides of the seat to
fold the seat together. Then secure the seat in the folded position.

7.2 Back height adjustment

Loosen the back cushion at the bottom of the back panels and pull the cushion end
forward towards the seat. Loosen the shoulder straps and remove the back padding
(Fig. 25 B). (Fig. 10)
Using an Allen key and an open-ended spanner, loosen the four screws enough so
that the back plate can be moved. (Fig. 11)
Ensure that the belt runs correctly during the journey. The green belt guide with the
vehicle's 3-point safety belt must always be above the user's shoulder. (Fig. 12)
Tighten the four screws again and attach the shoulder straps and the back pad to the
back of the back plates.
7.3 Back angle adjustment
Use the red eccentric levers on both sides of the Hercules Prime seat to adjust the
back of the seat to the backrest of the car seat. (Fig. 8) Make sure that the positioning
seat is in full contact with the vehicle seat.
7.4 Belt guide, top
7.4.1 Change of sides
Depending on the position of the Hercules Prime seat in the vehicle, the upper green
belt guide may be required on the other side of the seat.
First unscrew the black angle from the back plate (Fig. 13). Mount the bracket on the
other side of the back plate.
Now loosen the green belt guide on the black bracket and correct the position of the
green belt guide to ensure optimum belt routing in the vehicle. (Fig. 14)
45
2025-11